If the value is more than 2%, the results are not OK and if the result is under 2%, the result is accepted.Ĭapacity check error limit (works on CHG modules) - If we have connected charge sensors, we can perform the Capacity check. With Shunt calibration error limit, we define the maximum allowed deviation from the Shunt cal target value. Shunt calibration takes a while since it has to set several configurations and measure back the results. Shunt calibration error limit (works on STG, STGM modules) - The Shunt calibration can be used to measure and correct the resistance of strain gauges. When the sensor is read, we can see the serial number, settings of the amplifier and the sensitivity of the sensor. If we enable this option, we scan for TEDS chip only once or we can continuously scan for TEDS sensors and leave this option disabled. When we have sensors with TEDS chip, we have to scan it. Not resetting acquisition while timing is lost - with this option enabled, Dewesoft will keep recording even if the timing is lost.

Keep channel sample rate dividers - If the option is enabled the sample rate divider the sample rate dividers will stay applied.

Once this option is enabled, a new channel is shown in the system monitor.

Decode 2nd part of IRIG time frame - DS-Clock can now decode also 2nd part of IRIG signal.

Set SIRIUS sample rate limit to 204.8 kHz - Set maximum sample rate to 204.8 kHz for DW-43, Sirius, Sirius-CD and Sirius-HD.Use WinPCAP driver for EtherCAT device - With this option enabled, Dewesoft will use older EtherCAT drivers.Disable EtherCAT interface - Check this option if you do not want Dewesoft to scan or use EtherCAT devices.Always enable USB system driver - If Dewesoft USB system driver is disabled in the device manager, it will be enabled automatically.

This synchronization solution requires no additional hardware. The software synchronization accuracy is around 2-10 ms, which is enough for a simple temperature measurement. SoftSync sample rate limit - We can define the maximum sample rate limit if two devices are synced with SoftSync (e.g.If the speed is exceeded, the warning will be shown in the channel setup. USB speed limit warning (per slice) - Here you can define the USB speed limit per slice.Here you can find advanced options for different areas, like hardware, visuals, math, diagnostics and analysis.

Manually enable winpcap